Ramp drive for Goldhofer

With this drive set, the ramps on the Goldhofer semi-trailer from Veroma/Carson can be operated remotely! Our drive set is mounted on the model and controls the ramps with a geared motor. The upper and lower end position is secured with one limit switch each! The limit switches are already wired ready for installation. Only the cables have to be soldered to the motor! For operation a battery voltage of 6-8.4 volts is provided. If it is absolutely necessary to operate with a higher voltage (e.g. 12V), you can use a speed controller and operate it with only about 60% "stick deflection". IRAM: The operation is also possible without problems with our IRAM. There is no adapted version for this. Since the limit switches are already installed here, they do not have to be connected separately to the IRAM! This has the advantage that only the motor cables must be laid from the IRAM to the ramp drive.

Note: There might not be enough space for your steering servo next to the ramp drive motor. For this we will offer a new mounting option in a few weeks!

Scope of delivery:

• Gear motor
• Worm gear (worm pre-mounted on motor)
• limit switch, pre-assembled and wired
• new, continuous shaft for ramps
• Lateral caps for shaft
• new ramp holders, fitting to new shaft (laterally movable!)
• Gearbox housing base plate (acts as drilling template)
• Gearbox housing cover
• manual, screws, cable

Warnhinweis!
ACHTUNG: Nicht für Kinder unter 14 Jahren geeignet. Benutzung unter unmittelbarer Aufsicht von Erwachsenen.