Electronic switch with voltage indicator

The Powerswitch was developed as a replacement for the mechanical switch of the receiver power supply in combustion vehicles. The switch is used to switch the receiver power supply in the vehicle on or off. In addition, it informs you about the battery charge level or errors in the power supply. Attention: The Powerswitch is a pure switch, i.e. the voltage of the connected battery is transferred directly to the output when switched on. So if you use e.g. a LiPo battery with 7,4V you have to make sure that your receiver and servos are compatible with the higher voltage!

Power handling: Due to the latest MosFET technology, the Powerswitch is extremely resilient despite its small size. The use in large models with up to 3 servos is therefore no problem. Power consumption: Due to the very low power consumption, the Powerswitch can easily be connected to the battery for some time without completely discharging it. As an example: A fully charged 1600mAh battery would only be empty after about 950 days.

Features:

• Rugged and reliable electronic switch for receiver power for internal combustion vehicles.
• Completely sealed for protection against dust and water
• Programmable for 2S LiPo, 2S LiFe and 5 cell NiMH batteries
• Accurate charge level indication with 3 LEDs
• Fault detection loose contact/bad battery
• Very low internal resistance for lowest losses
• Extremely low power consumption when switched off
• Very high current carrying capacity
• Hardcase

Technical data operating voltage 3.5 - 10V max. current 10A power consumption (switched off) approx. 69µA Operating temperature range -10°C to +50°C, dimensions (L x W x D) approx. 25 x 17 x 7.6mm (without cable) Weight approx. 9g

Warnhinweis!
ACHTUNG: Nicht für Kinder unter 14 Jahren geeignet. Benutzung unter unmittelbarer Aufsicht von Erwachsenen.