Servo RHINO pro SHV digi 4

The RHINO pro SHV digi 4 servo is a 29 mm digital servo for use in large models. The new pro SHV servo is stronger, faster and more durable than our 1000-times proven RHINO digi 4. Stronger due to more torque, faster in actuation time and more durable due to the new 3-fold ball bearing, high-strength steel gearbox. The operating voltage range has been extended up to 8.4V for direct operation of the servo on up to 2-cell LiPo batteries. Especially when used in 1:5 cars, very high demands are placed on the servos. Here the RHINO servo has been the benchmark for years due to the generously dimensioned, extremely robust metal gearbox with 8 mm output for the servo arm. The integrated aluminum heat sink ensures effective cooling of the motor and electronics. The servo housing is protected against dust and splash water by sealing rings. Due to the enormous actuating force and robustness, this servo is ideally suited for large models (e.g. large F3A-XXL aircraft models) as well as for special applications.

The following parameters can be set using the MULTImate # 8 2094 test and programming unit:

• Servo direction of rotation
• Servo speed
• Servo travel left, right (max. 2 x 90°)
• Servo center
• Servo dead zone
• Fail-safe (On with servo fail-safe position / Off)
• Reset to factory settings

High-voltage (HV) servos

HV servos have a wide operating voltage range of 5 - 8.4 V. They can therefore be operated directly from 2-cell lithium-based batteries (e.g. LiPo, LiFe, LiIo). LiXX batteries have a higher energy density and lower self-discharge than NiXX batteries, which is why they are increasingly being used to power RC systems in models. Due to the higher voltage of LiXX batteries, smaller currents flow at the same servo power compared to conventional servos, which are usually designed for 4.8 - 6V nominal voltage. These must therefore be operated with an additional voltage reduction when using 2S LiXX batteries. This reduces the overall efficiency of the system, leads to unnecessary power dissipation, requires additional electronics effort and more connectors ( higher costs, greater risk of failure, more weight). Modern receivers (e.g. M-LINK) are designed for voltages up to 9 V, so with HV servos nothing stands in the way of direct use of the modern, superior LiXX battery technology. Further information

Technical data Dimensions (L x W x H): 59 x 29 x 55 mm Weight: 172 g Gearbox: steel ball bearings: 3 Multiple grinder poti: yes (with Indirect-Drive) Torque@ 6 V / 7.4 V*: 230 / 270 Ncm Holding force@ 6 V / 7.4 V*: 280 / 320 Ncm** Operating time for 40°@ 6 V / 7.4 V*: 0.10 / 0.08 sec.

• 5-cell NiXX or 2S LiPo operation. Data stabilized at 6.0 V or 7.4 V.

Warnhinweis!
ACHTUNG: Nicht für Kinder unter 14 Jahren geeignet. Benutzung unter unmittelbarer Aufsicht von Erwachsenen.