Kavan 3BD1005 FOXY 250 7.2V brushed DC electric motor

FOXY 250 7.2V brushed DC electric motor

The FOXY Brushed series of DC motors are perfect for a whole range of modeling applications - powering aircraft, ships, cars, tanks and other land vehicles with direct drive and gearboxes.

When installing and connecting FOXY Brushed motors, make sure that you do not exceed the permissible values for supply voltage and current load.

Cooling of the motor: During operation, the temperature of the outer housing of the motor should not exceed 80° C. Therefore, in the model it is always necessary to ensure sufficient access of cooling air and its flow around the motor. For marine models, we recommend the use of water cooling. High engine load is possible only for a short time. After each flight / trip, the motor must cool down to room temperature before you start again.

FOXY 250 7.2 V is a "250" size DC electric motor with 2.0 mm diameter shaft and sleeve bearings, suitable for powering indoor airplane models with direct drive (4x3.5" propeller) or with gearbox, for small car and ship models.

To control its speed you need an electronic regulator with a load capacity of 6-8 A.

FOXY 250 7.2V is a suitable replacement for SPEED motor 250 7.2V.

Technical data: Size: 250 Rated voltage: 7,2 V Operating voltage range: 3,7-8,4 V Speed at nominal voltage: 15000 rpm Diameter: 20mm Housing length: 25mm Shaft diameter: 2,0mm Weight 22g

The motor set contains: Motor FOXY 250 7,2 V Instruction