Kavan 3BD1000 FOXY 180 4.5V brushed DC electric motor

FOXY 180 4.5V brushed DC electric motor

The FOXY Brushed series of DC motors are perfect for a whole range of modeling applications - powering aircraft, ships, cars, tanks and other land vehicles with direct drive and transmission.

When installing and connecting FOXY Brushed motors, make sure that you do not exceed the permissible values for supply voltage and current load.

Cooling of the motor: During operation, the temperature of the outer casing of the motor should not exceed 80 ° C. Therefore, in the model it is always necessary to ensure sufficient access of cooling air and its current around the motor. In ship models we recommend the use of water cooling. High motor load is possible only for a short time. After each flight / trip, the motor must cool down to room temperature before you start again.

FOXY 180 4,5 V is "180" size DC electric motor with 1,5 mm diameter shaft and sleeve bearings, suitable for powering indoor airplane models with direct drive (3x1,2 " propeller) or with gearbox, for small car and ship models.

To control its speed you need an electronic controller with a load capacity of 3-6 A.

FOXY 180 4.5 V is a suitable replacement for the SPEED motor 180 4.5V

Technical data: Size :180 Rated voltage: 4.5 V Operating voltage range: 3,7-7,4 V Speed at rated voltage: 12600 rpm Diameter: 17,1mm Housing length: 18mm Shaft diameter: 1,5mm Weight 16g

The motor set contains: Motor FOXY 180 4,5 V Instruction